Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
To Hello,
In a CMOS double balanced Gilbert cell mixer, because M3 to M6 are operating as a switch, is baised at Vds = Vgs - Vt.
M3 to M6 have the same devices characteristics(W/L , Cox and so on) and since 2 of the FET are operating at any time with their drain current being equal, their...
gilbert mixer
To Hello,
In a CMOS balanced Gilbert cell mixer, M3 to M6 because they are operating as a switch, is baised at Vds = Vgs - Vt.
M3 to M6 have the same devices characteristics(W/L , Cox and so on) and since 2 of the FET are operating at any time with their drain current being...
design sequence gilbert mixer
To Hello,
Thanks for the reference.
Unable to open the ADS design file.
Where can I find a circuit with values indicated, like the W/L for the FETs, the resistors values, the Vgs, the drain current and so on so that comparison and confirmation can be done.
Thanks...
Re: Simulation for LNA IP3 and 1 dB com. point using Spectre
To Hello,
In SpectreRF how do you obtain the frequency response of a LNA?
At present I can only think of using S21.
In a CMOS inductive degeneration LNA with a cascode output configuration and a single connected constant current...
Re: Simulation for LNA IP3 and 1 dB com. point using Spectre
To Hello,
What are the best fi and f2 to choose for simulating a 1.2GHz LNA using SpecterRF.
T.P. Puah
To Hello,
Whats are steps needed to use SpectreRF to simulate IP3, 1 dB compression point and S parameters on a 1.2 GHz inductive degeneration single-ended LNA?
Thanks.
T.P. Puah
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
