Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I want to auto route as I have 226 object and a total of 707 pins, so no, it isn't a simple design. Without trying to sound "too" rude my original question wasn't answered, all I get back are lectures on how something should be done rather than either answering the question or saying "Gee...
Hi,
Thanks for the reply, however it didn't actually answer my question. I'm not concerned with placement of the components, I've done this manually. My concerns are over the fact that
the auto router didn't even attempt to route the two components on the layout. I'm questioning whether...
Hi All,
I'm seeing an issue when doing an auto route where (and it used to work), a couple of components do not route at all even though the ratsnest connects them to the correct end points. I've also had cases where I end up with an error because another track runs through the pins of the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.