Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello All,
In my design i am using differential pair and i have set all the rules required for the differential pair routing like clearance, matched net lengths, differential pair routing and differential width.
Everything is working fine but matched net length rule is not logging any Online...
Hi tpetar,
I have just updated first image.
my problem is
when i switch on the power supply voltage varies exactly what we want but the current is initially loading to 0.9A without connecting any load and a i can also vary(up-to 0A) the current but this should not vary.
Hi tpetar,
i have already checked the transistor it is good.
they used lm723cn regulator and ua741cn opamps(3 No's) in this circuit.
- - - Updated - - -
Hi picgak,
yes there is no output.
- - - Updated - - -
Hi,
I am able to vary it. but it is showing the current of 0.95Amp in maximum...
Hi Everyone,
i am using one transistorized power supply(voltage rating- 0 to 30V and current rating- 0 to 1A)
And now, the problem is in the channel 1 section it is getting initially loaded to 1A and am not able to vary it.
Please suggest me what may be the problem.
Hi Zia and TonyM,
Thanks for your replies, right now i don't have schematics i will send it tomorrow.
Can you please send me some probable reasons why it blows, in generally.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
