Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi, im new in altium, so i cant find a way to change default board size, i mean i have started my pcb, i need a 10X10 cm pcb board size, but altium by default have a board 4"x6" size, i have tried to set my pcb size when i start my pcb, but board size still 4"x6", so i have made my design in...
hi, im trying to change the size of the pins and vias of the footprints on my PCB, but i have several DIP-40 footprints, and the only way i can do this is manually changing sizes one by one, pin by pin, in properties, but i want to know if there is a way to change the size and shape of the 40...
hi, i need to print the artwork of my pcb design, because i want to make my pcb with PCB transfer film paper, os i only need to print bottom layer and later a second printing of top layer, question is how i do this, because when i print, all layers are printed
i use altium summer design 09
thanks
ccs read port
--------------------------------------------------------------------------------
Reading the compiler manual I can't find any instruction for reading the
entire port (for example reading the 8 bits of portb from b0 to b7)) at
same time. In PicBasic I made that with peek...
:cry::idea:
i had design a rf system to control a servo motor , problem is when rf transmitter and receiver is working, my pic has a erratic performance, so i believe my pcb pic is working as an anthena, i got my pic conected to ht12d an the pic controls servo signal
if a run the system using...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
