Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I've bought for few bucks a TDS 744A oscilloscope. It works fine but needs calibration. I've found the pdf for the technical manual, but not the 2 1.44 disks
that contains the software to recalibrate the scope. Does someone has it ?
thanks
proton
Hi,
I'm designing a brushless motor controller board, using a DSpic as a controller through PWM. The motor is a small 10W 24V part. I'd like to minimize the number of external components so I'd like to know if someone can suggest an IC that contains the 6 MOSFETs and the high side drive pump...
Hi,
I'm designing a control system for a motor, used in a dish positioning system.
The motor has to go to a certain angular position given by a compass sensor and keep
the position even if the base moves.
I've been using stepping motors and also fast microstepping motors.
Every 10 ms I sample...
Hi friends, I need your help for the following problem:
I've a stepper motor connected to a big mass , so with some inertia.
Suppose that I know that the position is at angle A and I want to move to
angle B, which is the best way of modulating the angular velocity (or if
you prefer the...
hp 5342a manual
Hi,
i need the service and user manuals for the HP 5342A . I know that
there is a TM manual around that can be downloaded from US military
sites .. but can't find it.
Any help is appreciated
proton
Re: which potocol ?
Hi,
I'm interested to the UDP solution but if I understand well I should
anyhow define a protocol ... someone has C examples that I could use ?
thx
proton
which potocol ?
Hi friends,
I've the following problem:
in a measurement system I have 10 stations each equipped with an
arm7 board running uclinux. About every 10 ms each station has to send
a data packet to a master pc using ethernet. Which protocol should I use ?
I mean: I could have...
Hi friends,
I need to interface a flash chip AM29F040 to a 18F8621.
Does someone has written a driver or has a piece of code that
I could take as example ? I program PIC using C (CCS)
thanks a lot
proton
Hi, I need the service manual for this instrument. I've the schematics
and the part list, but I need the few pages about calibration and repair, does
somenone has it and is so kind to upload them ?
If someone wants what I have for the 530 , please ask
thanks
proton
can_putd
Hi good friends,
does someone has a CAN driver and library for the CCS compiler to be used with
the 18f458 ?
I know that CCS has a develpment kit, so I wonder if someone can share the
code contained in the CD of the kit
thanks
proton
mt1389fe
Hi ,
does soemeone has the mediatek MT1389FE datasheet ? it's a chip
used for the divx players and have also an undocumented usb port.
thanks
proton
Hi, does someone has the companion software for the
CCS Embedded Internet Development Kit ?
They include a port of the microchip TCP/IP stack and some Email
and web server examples that I'd like to study
thanks
Proton
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.