Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I modified the design,but still its not working... I don't have much knowledge about sensors circuit..pls help me .....
Thanks in advance.....
Prasanth
Sir,
I have connected the components as you specified..but still i am getting the same error message..
According the error message: the sensor produces only milliVoltage and that is being given to the pic,but the chip requires 3.5V to 30 V ..I think pic is not getting enough voltage.. Is it...
I'm trying to read the temperature from a LM35 sensor and print it on an LCD display using PIC 16F877.. But I'm getting an error message in PROTEUS ISIS as 'Power Supply' (1.52v) is outside specified range(3.5v-30v)..
Pls help me .
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
