Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What i mean is, can i make one for me or is it for sale. i programmed my code to blink a led at portb pin 1 and its flashing on all pins and it only flashes when i remove the ground from pin 8.
I can use my friends pc for unlocking stuff.
Tell me how to make that fusebit doctor.
And, what i can tell you is that when i connect a 20mhz oscillator between xtal pins and i remove the gnd from pin8 and connect a led to any pin(but last code i wrote into mcu was to flash led at pb0) it...
Do i have to construct that fusebit thingy, if not how can make one on my own.
Parallel port programmer, I dont have a parallel port (i need a serial port programmer).
can some one tell me which software to use and also how do i unlock my mcu(maybe a tutorial).
i don't have parallel port on my new pc but i'll do it on my friends pc.
yep i think i messed with that ckdiv8 but i'm not sure if i messed before or after i faced that problem
---------- Post added at 16:18 ---------- Previous post was at 16:17 ----------
and i dont have any other avr
Hi,
i have a atmega168 and programmed it using a avr programmer circuit Getting started with AVR development
and i programmed it 3-4 times but after that i able to program the mcu but it didn't get any output on pb0 i programmed a led flasher this problem increased and and i ended up with a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
