Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by ppenday

  1. P

    [SOLVED] Corner & Monte-Carlo simulation in Cadence

    monte carlo cadence contact ankur kumar rajput regarding this
  2. P

    Matlab code for SAR ADC

    adc matlab code Hello, Does anyone have matlab code for sar adc. ex: capacitor mismatch Thanks.
  3. P

    Help me select ADC chip for measuring small changes in an analog ramp

    Re: ADC selection go for recirculating ADC
  4. P

    2.5V device at 1.8V supply

    Hello Vinod jain Bhai from FreeScale, Plot FT Curves, you will get maximum frequency of operation. Refer to baker lee site for FT curves setup.
  5. P

    OPamp and comparators' design

    thanks for the link ipsc
  6. P

    Best book for small signal analysis transistor amplifier des

    Re: Best book for small signal analysis transistor amplifier baker lee is the best book
  7. P

    What does the TT,SS,FF,FS,SF mean?

    ss ff tt TT - Typical NMOS, Typical PMOS S - slow F - fast
  8. P

    What is the requirement for PhD admission in UCLA, Berkeley?

    Re: PhD Query you need to take gre and toefel
  9. P

    Why do I get a pole-zero doublet when I do the CMFB stability test?

    spectre pole-zero thanks for the link pixel
  10. P

    OPamp and comparators' design

    opamp has negative feedback for stability and comparator has positive feedback
  11. P

    How to increase the unity gain bandwidth of a single stage differential opamp?

    Re: Unity Gain Bandwidth increase gm
  12. P

    Generating 3.3Vdc from 12Vdc

    resistor 12vdc to 3.3vdc use level shifter to get 3.3v from 12v
  13. P

    OP-AMP and voltage comparator

    opamp will have negative feedback and comparator will have positive feedback.
  14. P

    Overdrive Voltage ???? please help me

    overdrive voltage should be greater than 100mV for transistors to operate in saturation region. usually designers keep overdrive volatge around 150mV for safer side.
  15. P

    Question on Job Opportunity As Analog Design in Arab (Dubai)

    Re: Question on Job Opportunity As Analog Design in Arab (Du does anyone have idea about salary
See more

Part and Inventory Search

Back
Top