Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi...i use an atmega32 in my pcb board..my circuit was fine but i dont know what happened that after turning on the supply for (the last time) micro got so hot . with a multimeter in diode check mode it seems tracks of +Vcc and GND are connected (no power is applied to circuit)...and it seems 3...
hi...
after i switch my pcb.doc from 2d to 3d, i can see some component with 3d model but just in top view...i can not rotate the board to see my board in other direction ..when i click and move the mouse i can not see any thing but "action not available in 3d view"...is there any one to help...
need parametric sweep in proteus
i tried to simulate time transient result with a time varing resistor value (like parametric sweep in pspice) in proteus....but i dont know how to do it (i do not want dc sweep ,it is not time response). is there any one to help me?
how to simulate mc34063 in proteus
hello!
i tried to simulate boost converter in proteus but it is so slow about 10 min maybe to complete...i dont know whats the problem...is there any one help me?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
