Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks you tyassin. Ok, the magnitude of the reflection (s11) isn't constant with frequency.
I think to be constant, should be a circle. Am I right?
The second question is:
According to the circuit , why the magnitude of the reflection (s11) is not constant with frequency ?
Hello everybody
I need to answer this question :
After simulate with PUFF software the following circuit:
It's observed a spiral to represent the parameter s11 with the frequency in the Smith chart. Is the module of reflection coefficient constant with frequency? Why this should be done ...
Hello. I need find the scattering parameters.
To adapt a load ZL=50-100j ohm to a generator with output impedance Z0=50 ohm, is used a lossless structure as shown in Fig. Get the numerically matrix of parameters SA and S matrix of the two-port parameters remaining between generator and load...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
