Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Me too having the same prob as U., i teried working with x-ctu for terminal for serial., first command alone working fine for me., first command is "LLL" it gives ok for that and not any of the rest commands.., do give a try for X-ctu and rep me dude :)
use atmega 8 as a bridge between cc2500 and UART., bcoz cc2500 operates in SPI., which is quite tedious to study all those data sheets., so ., access cc2500 through atmega 8 from UART. i m using AVR 128 uniboard... i will check abd reply u with the codes
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
