Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am trying and trying,without succes
i ad dimensions to the previous patch image,(maybe is something wrong)
dielectric material kuprextit FR4... Er=4.4; tan delta=0.03; h=1.58mm
height of copper is h=0.035mm
resonant f=2560MHz
but i need to have square patch with truncated corner,(at least rectangular patch with trunc. cor.)
now it look like this
as i mentioned before,need circular polarization, instead that linear i have. but dont know how
i ma not sure if i understand what you mean by perturbed into an ellipse and fed properly, can you be more specific please
image is here
https://www.edaboard.com/threads/198094/#post831715
hi all,
can anybody help me please, i am solving university project.i have already created the corner truncated patch in CST,with single microstrip feed line.
(FR4 with Er=4.4, h=1.58mm,height of copper h=0.035mm),
it should resonate on f=2560MHZ and input impedance Z=50Ohm
i used known...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.