Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the reply.
I'm uploading the corrected schematic. This is what I'm exactly using to make the circuit. I'm a newbie so please let me know where exactly should I use the 1Mohm Pot?
Hello friends,
I'm using the attached circuit for getting the galvanic skin resistance. The bridge circuit is working fine and I'm able to obtain resistance output as required (points Out_1 and Out_2 - varying between 0.8M - 1.5M ohm) but the op-amp circuit is not functioning. I'm not getting...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
