Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Thanks for the link tpetar. But I was wondering if I can employ Gyrosope to do the same thing, it will also help me to understand the Gyro concepts as well. Any help on Gyro to acheive the same objective?
Thanks for the reply guys.
I have a very strong magnet that I intened to connect to the shaft. This magnet will house the circuit, so the whole system will be rotating with the shaft. The shaft diameter is about 2 inches. After measureing speed, I intended to log the rotation speed for later...
Hi all,
I was wondering whether I can use an accelerometer or gyroscope or both to measure the speed of rotation for a motor shaft. To be honset I have read alot of stuff on the internet but am kind of confused as to what will be the best solution.
Basic idea is that If I can mount my circuit...
Hi,
Can you please suggest me various current loop transmitters, please do not suggest XTR115, XTR116 or XTR117. I want to power the external circuitry via the transmitter. Any suggestions will be highly appreciated.
Hi,
I am designing a circuit, in which the signal level rises to the maximum of 24V, but there is a potential that somebody can wire 230VAC to the input supply instead of 24V. I need to design a protection circuit that uses SMD parts to create the protection from 230VAC.
The circuit I...
Dear All,
I have been working on a prototype of Buck converter, I have been using PIC18F25k80 in order to generate Complementary PWM using ECCP, I am only using one of the PWM pin at the moment for switching Logic MOSFET, as in the future I would like to make the Synchronous...
Dear All,
I am looking for an example project or tutorial that utilizes C language or Microchip Library to configure two PIC 18 using I2C. Any help or direction will be highly appreciated.
Best Regards
Hi, I am designing a Buck converter, which has the following requirements.
Vin = 12v-14v
Vout = 3.3v
I load = 160mA
I need some guidance and information regarding stability and phase margin.
I have different options for choosing the IC,
Option 1: ADP2302: 2A, 700KHz NonSynchronous...
Hi,
I am designing this very simple low pass filter, and also with the view to drop the Voltage to 3.3v from 24v.
Here are the specs: Cut off frequency: 297 Hz
I started initially with the following combination:
+24v
.
.
R1
.
................C....Ground
.
.
R2
.
...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
