Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
Please tell me how to drive the Printer mechanism of M190g dot matrix printer.
I am not able to print the dot on the roll paper.Please help its urgent.
Re: interface printer to microconroller
Our printer mechanism M190 G is connected to the LPC 2136 Microcontroller.
We are able to print dot on the roll paper. But its not on the proper location & manner.
I am not able to fin new dot line.please tell me Every R signal state change the signal...
hi
My printer mechanism M190 G is connected to the LPC 2136 Ucontroller. I am able to print dot on the roll paper. But its not on the proper location and manner.any one have example driver to drive the mechanism.Every R signal state change in M190g is new dot line...?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
