Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello. Well after the 3rd time getting hit at work, this last time was major damage... of course no one said anything. I suspect that the issue is parking. The parking lot is a crappy design. Anyways, I built a bull bar for the rear bumper (its a truck) but I need some type of proximity device...
Maybe a link to a servo, motor, stepper to help out? Not sure what I should be looking at, as mentioned previously, self centering is what we are aiming at...
Thanks! So the consensus is that a servo will NOT support the gimbal weight and head weight? However, I from what I understand, a stepper might work, but might not spin fast enough? Plus I assume stepper motors do not have an auto center... this project is turning into a nightmare. Thanks... I...
Re: Need some help with schematic and (code?) for RX / TX servo controller project
Unfortunately the member that was going to help me was not familiar with servos which is what other members suggested I use. Can anyone else help me with this project? Thank you.
One of the members here has been kind enough to help my son and I with a school project. Basically it is a pan/tilt gimbal that will have a mannequin head on the top that is controlled wirelessly by a head tracker - so as your head moves the mannequins head should also follow suit. I don't...
I am trying to assist my son with a science fair project. The fair is based on wireless technology, so my son would like to make a robotic head. The basic design is a gimbal (pan/tilt) with a mannequins head on it. My son, would like to be able to push a bottom (on/off) on the TX box that will...
Power intake will be from solar and testing it yesterday showed power fluctuations from 5 volts dc .85 amps to 3.5 volts .4 amps. due to clouds or more important its a non tracking system. The charging circuit I am using uses a chip that is only good until 5.5 volts. Can someone suggest or post...
Ok, so let me get this right. The PROG pin with a resistor at 500 ohms, will have a max current outout of 2A. Now if it has a max current limit of 3A and my power supply provides 3 amps MAX, could I change the PROG resistor to 333 ohms for 3 Amps max?
Also, the Vin/PFI/PFI-RET split resistor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
