Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi - Hopefully someone can help me. I'm looking to send an SMS message using an Arduino. The phone I'll be using is the Nokia 5110 with FBUS..
I've tried everywhere to find some example code, I find this the easiest way of learning and then developing to my needs, but nothing.
Anyone help...
12v filter
Hi
I want to make a 12v filter for an audio system fitted to my motorcycle. It appears that the engine noise is affecting the performance of music I hear and mobile phone communications.
Any ideas for a filter to add to the 12v power line to help address the problem?
I have...
top tyco omron hke
Can anyone help with a suggestion for an alternative relay for either of these OMRON products:
G2RL-1-12V or
G5S-1-12V
Trouble is that I am constructing on a PCB which is already made and therefore the footprint and spec must be similar.
I'm struggling to get one of...
baud rates for gsm to pic
Would you mind posting the differences? I'm planning tomorrow on building a cable for my PC and one to later connect to PIC using this system:
http://www.piclist.com/images/boards/thebug/index.htm
The schematic just shows a connection to RS232. I presume I need a...
pwm rs232
I have managed to sort the PWM for a small motor control, code attached.
1 How can I now control the voltage using RS232? I have a TTL convertor ready to go. I guess what I need is the changes to the code and hopefully some sort of VB app to control the motor.
2 In addition...
Yes please to a board, let me know how much and how you want the money? PAYPAL :?:
I'm very interested in the new code, thanks.
I note you are using a Wavecom, I have one of those but I would like to connect a Nokia 5110 and use AT commands in the same way.
Have you considered setting a...
Excellent, that's great.
Are the boards available?
Piers
Added after 2 hours 34 minutes:
Also :D I'm intending on making this on breadboard first. Do you have alternatives to the BAT54's?
Fot the NPN's I was intending to use a 2N2222 and the PNP a 2N2905.
Should they be OK?
Would anyone have seen or have a project such as this.
A device that is activated on movement (tilt switch) which takes a series of 20 photos from a camera and delivers them to a specific number using 3g?
Thanks
Piers
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.