Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
elektor reflow
Hi, i'am tryning to redesign elektor's reflow oven from december 2007 to use a 64x128 LCD with KS0108 controller.
The code from elektor is for a S6B1713 controller, and i don't now how to make code.
Best regards
PicBlaster
Hi. FvM and House_Cat
thanks for the reply
I'm use sommer08, and there is not a mirror for NC that i can find, and i don't have CAMTASTIC or CAM350
I have NCPlot but it's cant't mirror.
PicBlaster
camtastic cnc
Hi,
I've made a NC drill file in protel, and now i have to drill the singelside pcb board with my cnc machine, but the NC drill layout i displayed from the Top layer, and i want to drilled it's from the bottom layer.
please help
best regards
PicBlaster
Hi, i have a USB PIC programmer, that i want to use on my old notebook, but the notebook has no usb-port only rs-232 ports.
I have search the net, but only found some circuits for USB to RS-232.
I hope you can help me !!!
best regards
PicBlaster
Battery pack charger
Hi, i'am searching for 12 cell charger circuit layout for a Ni-MH or Ni-CD battery pack for my notebook.
The battery data is
SKD III
Ni-MH Battery Pack
1.2*12 180mAH
Please help, i've search google without lock.
Have a nice weekend
PicBlaster
Need some help please
Hi i'am trying to build this PCB drill machine, but i'am not very good in programming, can someone PLEASE help with this project. The code listning is from page 29 ->.
Best regards
PicBlaster
Hi, i need some help, i have a parallel controled stepperboard for my cnc machine. But i want to use my old notebook to controlle the stepperboard and the notebook has only a serialport, is there a way to do that ?. The software i use to controlle the machine with, have setup's for both.
Best...
Hi, i need some advice on a good and easy use schematic simualtor, it's to be uset to simualate stepper circuit and microcontroller etc.
Best regards
PicBlaster
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.