Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Klaus,
Thanks for your response. I'm having a hard time getting the motor manufacturer to understand my question.. Or maybe I don't understand the answer :/ He says that at 10% duty I should stay below 120 VDC, and at 100% 40 VDC. But doesn't 40 VDC seem awfully low for a continuous rating...
Hi all,
Be warned, mechanical engineer here. I'm working on a project with a DC non-commutated linear moving-magnet voice coil, controlled with a servo drive in current mode, and I can't seem to get a straight answer from the manufacturer on the maximum voltage the device is rated to.
The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
