Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
1.
Schematics and design attached.
2.
Test Results
3.1
The load regulation, was around 3-4V now. However, on 3A load, the Transformer, Topswitch, Output Diode (D3), and D1 were getting too hot (schematic attached for reference). When we went for ripple testing, the supply got faulty and the...
I am trying to make a power supply. I have a 48V 3.5A output.
Load Regulation is very bad and some values are-
At no load, output voltage = 48V
At full load(3.5A), output voltage=32V.
I am attaching the FLYBUCK SMPS POWER SUPPLY CIRCUIT. Please suggest me some solutions to improve load...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
