Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by Peter74

  1. P

    Sending Digital Data TX-RX in a noisy environment

    Thanks a lot for your reply. So thinking to send them optically is not a good effort since the accelerator produces a lot of x-rays. After severe calculus the current should go down to 20uA (heeeelp!) And the ADC is now connected to USB to the PC port. Sorry for the varying values but they are...
  2. P

    Sending Digital Data TX-RX in a noisy environment

    Hi. Forum! It's me Peter and I need your help! For my Master Thesis's Measurements I need to send analog acquired signals (4 currents of 10-20mA each) in a noisy environment (an ElectronBeamAccelerator that stays inside a bunker) 40meters away outside the bunker to my Instruments. I have the...
  3. P

    NEWBIE Question: Howto flip instances in Virtuoso schematics

    virtuoso upside-down instance Hi forum. I am getting mad about a problem. :?::?: Since I need to design a differential input pmos OTA i need to flip (or mirror) one pmos so that it appears mirrored to the other (the source upstairs) I have searched the manual but cannot find howto flip my...
  4. P

    Fully Differential Folded Cascode OTA: 50dB through 400Mhz !

    fully differential folded cascode ota Thanks alot. I am beginning this way. Your help was Very appreciated
  5. P

    Fully Differential Folded Cascode OTA: 50dB through 400Mhz !

    folded cascode ota Hi forum. For my exam in Analog Design I was assigned to Design a Folded-Cascode OTA with the following Specs in 0,35um tech: CLoad=5pF Open LoopGain = 50 dB Gain Bandwidth product =400Mhz Phase Margin =45 Input Offset Voltage = -+15mV Peak2Peak Output Range = 0,8V Iref=...
  6. P

    AMS HIT-Kit v3.51 p-well not avaliable & unbound variabl

    p-cells hit-kit Hi everyone. When I start Cadence IC5.141 on my CentOS_3.9 machine with my script: ams_cds -t c35b4 & I get the following WARNING in my LOG file CDS.LOG: ...................................................................................... \o austriamicrosystems...
  7. P

    Aust*iaMi*roS*stems C35b4 technology

    c35b4 Hi. Have succesfully installed Cadence IC610 on my CentOS 3.9 O.S. and Cadence is running quite good. I'm a student and new to the software. I need to make an Op-AMP in c35b4 technology founded in the AMS_HIT-Kit 3.7 version. Why cannot I find it on the Cadence DVD? Somewhere I wrote that...

Part and Inventory Search

Back
Top