Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by peter g

  1. P

    power supply

    my line voltage is 120v. need 0-100vdc, either linear or smps. isolated. 30-50ma. i need this supply to test for leakage in electro caps.
  2. P

    power supply

    current required 50ma. powered from ac line.
  3. P

    power supply

    hi, i'am looking to build a 100vdc, variable, regulated power supply. does anyone have a circuit they will share with me? thanks.
  4. P

    stk544uc62ke

    hi all, need a STK544UC62K-E. they're sold in multples of 8 and 10. where can i buy one?
  5. P

    ZENITH PLASMA Z50PX2D

    the dots are visable at the top of picture.
  6. P

    ZENITH PLASMA Z50PX2D

    hi, the dots that are present are not noise, but rather perfectly round white dots, that vary in number.
  7. P

    ZENITH PLASMA Z50PX2D

    hi, i'am having a problem with this tv. the picture comes on with 6 vert lines across the screen. these vert lines are filled with white dots that vary in number. have good color, no other problems with video. sound gets static as number of dots vary, can anyone help. thanks.
  8. P

    gints oleg (GO) esr meter

    I spoke to soon. still having problems. I did the adjustments and the meter adjusted the way its supposed too. the problem now is it won't measure esr of a capacitor larger than 500mfd. display shows all zeros?please help! - - - Updated - - - I spoke to soon. still having problems. I did the...
  9. P

    gints oleg (GO) esr meter

    trouble found (solder short) all is good.
  10. P

    gints oleg (GO) esr meter

    hi krypton, finally got around to adjusting the go esr meter. been pretty busy cleaning up after Irma. when I short the test leads and hold down the plus switch, the display shows the one ohm and 10 ohm correction factors screen? so cannot zero adjust. the whole calibration procedure seems...
  11. P

    gints oleg (GO) esr meter

    thanks a bunch krypton, i'll try it and post back.
  12. P

    gints oleg (GO) esr meter

    hi forum members, I have just finished the construction of the GO esr meter. i'am trying to calibrate it. the problem is, the zero adjust drifts after its set. has anyone built this meter? i'am not sure if i'am adjusting it right. help needed. thanks.
  13. P

    isolation transformer use

    hi all, i'am planning on taking waveform measurements in a plasma tv. I will be using both hot and cold grounds. the isolation trans that I have were made for tv servicing. my question is, do I use two iso trans, one for the tv and one for the scope? as I recall the scope shouldn't be isolated...
  14. P

    negative voltage regulator problem

    unfortunately, the res checks good. i'am going to start over, make a new board use all new componets and will post results. meanwhile, thank you for your interest I really appreciate it. bye for now. pg
  15. P

    negative voltage regulator problem

    will check resistor. post back.

Part and Inventory Search

Back
Top