Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
This is a good question, and a good choice of this architecture is critical to the success of your project. As you said zero IF architecture has fewer components but has complex problems such as OFF-SET, and ficker noise. If you choose the Low-IF architecture with an IF frequency of very...
I'm using the da_ic mentor graphics to simulate the behavior of the phase noise.
How can i configure the parameter of the phnoise source like: PHN_SLOPE, PHN_CORNER and the setups of simulation?
I have the graphic dbc/Hz at frequency of my device
Sorry, but your question isn't clear for me
do you like one tunner to convert the signal of the DVB to one IF=37~40MHz, and use one software to demodulate the signal OFDM?
If are this your problem: i will recommend you look components like: MAX3541, MC44S803, etc....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
