Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I was hoping to get some feedback with a board I am designing. Its basic function is to control a 9g rc servo motor when it detects a change in the photointerupter. It has two modes of operation controlled by a switch. The brain box of this guy is the ATTiny85. There is a ground pour only on...
Thanks for all your feedback guys! As I'm sure you can tell this is my first PCB.
srizbf the power supply is capable of 3 amps. I will add bulk capacitors in the next rev.
KlausST I will work on implementing your comments in a rev 2 of the board. Thank you so much for the thorough response...
I am creating a project that reads a photo interrupter and controls an LED and Servo. The setup mode where the led turns on when the photointerupter in interrupted works fine but the mode where the servo goes off isn't functioning like on the breadboard. I didn't realize that on the breadboard I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
