Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi to all,
I work on a Photoplethysmography (PPG) Project with a customised Optoelectronic Sensor to monitor vital signs where I acquire the signals (PPG + Accelerometer) from the sensor to a customised board for all the necessary analogue signal processing and through DAQs to LabVIEW for...
Hi,
I am trying to make a dual-side PCB by combining at one side the **broken link removed** (without the pins except + and - ) and one the other side the **broken link removed**. I am trying to make this PCB as small as possible in order to fit it in a miniature portable device. My question is...
Hello,
I have a circuit arrangement project with different parts for a prototype portable device which you can find attached. I would like to make a single pcb out of this circuit so that I can fit it the portable device. As it is, it works perfectly. I also have all the eagle files for the...
Hi I have connected a https://www.sparkfun.com/products/10999 with a **broken link removed** for a small project
The circuit that has been created is shown in the following link:
**broken link removed**
My question is that I would like to replace the 9V battery with the following 3.7 V...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.