Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Unfortunately controller can't do that. It was designed for simple operation to convert show lighting equipment DMX512 protocol in to puls/dir signals. There is no possibility to change anything in controller. I need to smooth motor start/stop somehow after controller, and this is probably can...
Colleagues,
I am working on one very specific product and required to find stepper driver with possibility to adjust acceleration/deceleration. Without this function my steppers loosing steps. This function need to be applied only in driver, because i am using very special controller to generate...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
