Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
No problem. I would like to have a clear understanding of how to use the program. I know all about antenna's but not about this program. The video's they have on how to use it are very unclear and not made for new people.
Hi, Who can give me some one-to-one PM support in using CST ?. I have a two frequency (900 - 1800MHz) antenna that I would like to model and optimize but I am new to CST.
Thanks for suggestion but I know this device. It only works from 0.9 - 1.9V not the 3.6V I asked. Its also a pricy device as I know, maybe you know to get it cheap ?
Best option I have is the EM: EM6819F2-B006
I know there is a device from Korea/taiwan that is for sale in China but I can't...
AVR ATTINY43U. is almost 1.80 USD so not near the 0.40 USD I am looking for. and google did not give the answer I am looking for that is why I try here to dig some brains.
- - - Updated - - -
EM does have a device but cost is to high and I do not need 6 or 8K with EEPROM, ADC etc.... I need a...
I think you did not read my question !. I do know the whole PIC, AVR, Cypress, Freescale, Elan, Holtek, TI, Silab product range. I look for 0.8V operating voltage and cost below 0.40 USD @ 10K.
Hi, I am looking for a low cost small MCU with about 1K memory minimum 4 I/O lines and able to operate from 0.8V upto 3.6V minimum and using less than 20uA if in sleepmode. Must be able to wakeup by internal timer.
I am looking for a PIC10F but than operating at 0.8V...
Who knows ?.
Hi Daniel M,
No matter what people write (writing 16 bytes and than trying to read, means you FIFO is to small or you have to check more frequently) the code is very simple and fast AND Secure used in a proper way.
The inputpointer normally counts from 0,1,2,3....15,0,1,2,3 you see it is going...
As FvM already told you have to use APF type of filters and they use a notch filter structure. FFT is not used for this. They are completely digital and track the fundamental signal and suppress this signal in the digital frequency domain. PLL's are not usefull for this, its possible but it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
