Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
zero bias drain conductance
Hi all,
The channel noise of a mos transistor depends on zero bias drain conductance gd0... what does it really mean? zero-bias (is it bias gate equal zero or drain zero?). How could I extract from simulation this parameter?
what about γ and δ? how could obtain...
You could close your circuit and see if there is the noise at output. Put this noise source (grounded at one side) in series with your resistor and ground the resistor, and read the output on the resistor.
Best regards
Hi all,
The channel noise of a mos transistor depends on zero bias drain conductance gd0... what does it really mean? zero-bias (is it bias gate equal zero or bias drain zero?). How could I extract from simulation this parameter?
what about γ and δ? how could obtain these parameters from...
Hi wccheng,
At first, you could verify if your ifoutput matches the ifport because your if frequency is high. Secondly, try to see your oscillator, because your mixer depends on its amplitude (have you swept the power of the oscilator to increase the conversion gain? is it matched to the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
