Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi all,
i am a newbie...
how can i interface the ht12d and relays..
here i will connect motors to relays the the output of ht12d should be given to relays ... i am confused about how to connect the decoder output to relays .
hi all,
i am new in developing the electronic circuits. so i need some help from u...
i am using HT12e for encoding and ir as the medium to transfer the coded information and HT12d to decode the information acquired. i want to give the decoded output to motor driver L293D.so can i directly...
i am new to embedded systems designing...
i am trying to move the robot in all directions using ir rays...
i am ready with the receiver part i.e of ir sensor ...
but i am lagging with the knowledge of transmitter coding and how to pass the signals with that code i.e 0's,1's .
is there any ir...
hi all,
i am new to embedded systems designing...
i am trying to move the robot in all directions using ir rays...
i am ready with the receiver part i.e of ir sensor ...
but i am lagging with the knowledge of transmitter coding and how to pass the signals with that code i.e 0's,1's ..
can...
hi ,
if we use ir transmitter for controlling a motor .the transmitter requires any coding?
here i am using AT89c51 microcontroller. my motor robo should move front , back right and left
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
