Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I'm having troubles to run the simulation of S Parameters in ADS 2011, yesterday it was working good, today I open the workspace and show the same message when I try to run the simulation. This happen in every schematic I have in the workspace.
Message: Unable to start status...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.