Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
here is my hfss file.
In this file I used a lumped port and characteristic impedence resulted 46 Ohm so close to 50.
my problem continue,instead, with waveport I can't get the 50 Ohm impedence with port solver even changing more and more time the dimensions of the port
thanks
hfss ports only
hi I am very new to using Ansoft HFSS and this is my first post and I need your help:
my project is a circular loop antenna over a substrate without ground plane so the signal must be taken in differential mode.
I choose a waveport but I don't know the exact dimensions of...
1)my vmware version is 5.5.3-34685
2) I don't understand what you mean
3) J've just installed vmware tools
4) no,it's scsi (0:0)
in the image you can see what happens when I launch 'startx' at the command shell, after I installed vmware tools!
Hi, I 'm a beginner of Linux and of this forum and I'm in a trouble.
Since I need to keep Linux on Windows I've installed Vmware and then RH 7.3 on it as guest OS because it's the best version for Cadence IC:
1)first of all I need to know about the question of the color depht requested by...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
