Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
element thickness
I am designing yagi for 910 Mhz.
I designed yagi using freeware program quickyagi(qy4) and i
am trying to simulate it using nec2 (4nec2).
what i found using simulation is "Decreasing element thickness increasing gain"
Is this correct ?
To increase gain, if i go on reduce...
Yagi Antenna Basics
I am learning about antennas, and i need to build a Yagi for my project. I have some doubts on basic yagi structure.
1. I am designing 4 element yagi for 800-900 mhz ISM band. After
fabricating, can i put that inside a plastic enclosure ? will that
affect...
I am trying to make a rf switch board with one input and two outputs.
Using that input signal can be connected to any one of output depending
upon the control signal.
My Requirement is track's impedance should to be controlled to 50 ohm.
How to do these ?
Since , it is very simple switch...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
