Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
Is there a way of removing all wires on the pcb layout on ARES? I did a auto routing and then saved it and closed the application so I cant Ctrl z.
Thank you,
Owen
Hi all,
I'm trying to create a 4 layer PCB with the first layer being signals and components, the second being +Vs, the third being GND and the bottom layer being signals and components again.
Ive selected the 4 layer design layout in ARES, however I haven't assigned any layers to either +Vs...
Hi all,
I'm using the Proteus professional 7 and I'm try to get a grid snap size of less than 0.1mm. I've looked at the help menu and it just says use fine snap, but doesn't say where to find it?
Thanks,
Owen
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.