Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the tip.
It keeps saying" The signal reset_IBUF has no load. PAR will not attempt to route this signal." Is this warning negligible?. The reset signal is already an input why should I load it?
Re: transient response
As much as I remember from control systems classes; the inner dynamics of systems causes transient response when input has rapid changes. transient response shows itself as oscillations and overshoots. To overcome this 'velocity feedback' or 'derivative control' is...
Hi;
I am trying to send data to Spartan3 board via Hyperterminal. My aim is to display the ASCII code of character entered on leds. I designed a state machine but I can't get any output result. Any ideas?
/*
Initially it waits in IDLE ;
when receiver turns into 0 (start bit) it goes to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
