Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi folks,
I have recently graduated from a technıcal unıversity in Netherlands and couple of my friends have started working as Analog design engineers ın Belgium. I think the salary level is more or less the same for also verification engineers.
I would say 2000eur (net) is good for entry...
12 relay driver circuits
Hello,
I need to drive 32 NEC EA2 relays on my pcb but I want to use minimum number of driver ICs.
I was thinking about driving 4 relays from 1 output of ULN 2803 but from the datasheet I couldnt find out whether its possible or not..Besides I dont have any samples so...
I have attached the circuit. The tech is 0.18 Tsmc
The point is I have designed the circuit such that my input range is to be btw 0.6 V and 1.2 V . While I sweep one input from 0.6 to 1.2 and the other one 1.2 to 0.6V using Voltage controlled voltage source at the input, I see a gain of around...
I am designing a fully differential miller ota in 0.18u technology.
At first stage I observed the open loop gain but I could not observe the
closed loop dc sweep. My CM range is 0.6 - 1.2 V .
I searched the internet but there is everything but the simulation techniques.
Can you please explain...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
