Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
install ic5141
i am about to install Cadence in a Solaris server. We should use it for 4 years continously from now on.
Which version is recommended?
What are the differences between IC5141 and IC61x excpet that their data format are different?
Is IC6x popular in industry now?
Thank you.
changing from cdb to oa
Hi,
I tried to convert tsmc018rf from CDB to OA. But, after converting, I found rfnmos2v, rfpmos2v, nmos2v and pmos2v miss their layout. Does anyone know the possible reason?
The attachment is my conversion setup.
thank you
onandon
cadence ic 610
what kinds of libelf* files do you have in /usr/lib?
maybe you can try to install libelf1 through synaptic and make a libelf.so.1 link to the corresponding libelf file in /usr/lib
installing cadence ic610
hi, holddreams
you can try the following
How can I fix the following errors?
/usr/local/cadence/IC610/tools/dfII/bin/icfb: 97: cds_plat: not found
==> check whether you have installed csh
/usr/local/cadence/IC610/share/oa/bin/sysname: 328: /bin/awk: not found
==>make...
thanks.
unfortunately, i have to design with cmos.
for NF requirement, we need to get it from the calculation based on the system spec. but i am not sure what value is reasonable or achievable. maybe i need to check some commercial products. hopefully they would mention it.
thank you, khouly.
yeah, lots of paper talk about RF envelope detector in power amplifiers design. In this case, they care the linearity, not the noise.
But, there is still some paper mentioned envelope detector as weak signal detection just after LNA. They do not mention about the noise...
I am designing RF envelope detector with CMOS operating in sub-threshold, based on Meyer's topology[JSSC9501,Low-Power Monolithic RF Peak Detector Analysis].
The envelope detector is said to be noisy. Then the noise performance should be an important criteria for the design. However, when I...
There is ADS2006 Linux version and you can find the installation instruction in Agilent website. Ask your labmate or teammate who manages the CD to get it.
By the way, if you install in Ubuntu or other debian based Linux distribution, you need to set up sth to make it work properly. you can...
Normally, when we simulate the oscilaltion of an LC oscillator, we would add some excitation such as a pulse signal to the oscillation node to excite the oscillation. However, that is not the real case.
Now I tried to simuate the build-up time of an oscillation excited by noise and input signal...
1. How could I simulate the noise source in Cadence?
2. How should I config the options(conservative, moderate or liberal and etc) when I run transient simulation in Cadence to check the start-up period?
The start-up periods are different with different transient simulation configurations. Is...
Ubuntu
is there any way to intall ADS on ubuntu? according to its manual, ADS linux versin only support Red hat among all linux distributions
ADD:
refer to to make ADS work properly in ubuntu
Re: vmware substitute
you can try Virtualbox. there are both bianry version and open source version.
https://www.virtualbox.org/wiki/Downloads.
onandon
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.