Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
tranformer less power
HI ALL
im try to make a lowest cost power suply
for a smal cosumer aplication :smile:
im need about 500mw (5volt 100ma) but a lowest posible cost he he (input 220vac)
some one have desing rule for capacitive coupled power suply or zener or ather desing
dut it must be a...
hi
ok if is fbi endosed it work on the
edge detection manner for sure :smile:
it a bit complicated to explain but
if you need im send it to you a couple
of draing to tryt to explain the principle
of detection :smile:
<font size=-1>[ This Message was edited by: omega on 2001-05-29 19:54...
hi
image compression ????
is much beter to perfom a edge detection
algo end the store oly the cordinate of
some of specific edge :smile: then whit some fuzzy logic you must perform the reconition
reconition of the whole image let the
chanche of mis interpretation ....
due to variation...
hi
did you try the atmel "FDC4B14" ??
it work verry whell end it less
sensitive to esd tha many other sensor :grin:
http://www.atmel.com/atmel/products/prod342.htm
a+
<font size=-1>[ This Message was edited by: omega on 2001-05-28 18:54 ]</font>
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
