Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need to construct a circuit that takes in 3-3.7V, 2amps and outputs 5V, 1amp....instead of going through the stress of the common local etching, drilling and the rest of a copper clad...I would prefer to consult companies who takes in your design, comes up with possible circuits and design...
MC34063 utilizes 3v-40v input
and u can get a maximum current of 1.5A
so it still can be used..cos i require an input voltage of about 3.3v and an output of 5v(500mA or 0.5A)
i need to step 3.1v-3.7v(input) to 5v (500ma)(output) using mc34063
Already tried different combination of resistors, inductors and capacitors...
also tried values from mc34063 calculator but no good result.....
anyone with help?.......please
specifics will be very much appreciated....
i also...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
