Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: RS232 communication between PC and FINGER007 + FGR006
problem solved after initialization button pressed at the back of circuit. guessed id overlooked this.
thanx
Re: RS232 communication between PC and FINGER007 + FGR006
thanks FoxyRick. Sorry was in a hurry not to notice the section (FPGA). Shall let all know of the outcome
Hi everyone. FINGER007 is a fingerprint identification access control system, while FGR006 is a fingerprint identification proximity reader. I have connected the two together (one outside the door and another inside the house). Im trying to make a connection between these and a PC via RS232 but...
im building a moving message display using attiny2313 and 12c eeprom. my problem is that when i start the program (leddisp.exe), then i open the font (basic.ldf) and then click on the "Write font" button, it shows "Writing font" window then nothing happens!
THE SITE I GOT IT FROM IS: **broken...
pliz there is this member called Electronicus; he said he successfully did the project and it works for him fine.now im reduced to checking out if my serial communication ports are ok. i managed to write the basic.ldf font into eeprom using ponyprog and some eeprom programming circuit i built...
hi, im building a moving message display using attiny2313 and 12c eeprom. my problem is that when i start the program (leddisp.exe), then i open the font (basic.ldf) and then click on the "Write font" button, it shows "Writing font" window then nothing happens! please help
at 2313 programmer
im doing my project regarding scrolling message display comprising 7*50 arrays of LEDs.I have the program/code to display and scroll alphanumeric set of characters.
Here is the Hex code you need to burn into your ATtiny2313 microcontroller...
ispprog attiny
well im wondering if there is an easier way to interface my PC and hardware via serial port. im building a running message display with 7x50 LEDs.i tried to program ATtiny2313 using the parallel port of my PC (winXP) unsuccessfully,but then succeeded to program it using ISPPROG...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
