Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
apparently yes, i saw this online and they connect it to a NI USB 6008, but i don't wish to get a NI USB 6008 for maybe a 1time use, therefore i am seeking other alternative to replace it.
actually now i am thinking how can i connect my Vo to to arduino pro mini
since i can connect my arduino via usb to my laptop and use energia to do my code
my range that i am interested in is frm 380-780nm
cause i read online, that with my Vo and i connect it to a NI USB 6008 it can produce data in labview when the program is done,
i want to try not to buy the NI USb 6008, therefore is there method that it can replace and use program such as...
i can connect a NI USB 6008 at Vo and use labview to create my "INTENSITY vs WAVELENGTH"
but is there other cheaper alternative that can use to connect Vo to my comp and plot the same graph ?
ok, i getting abit of the picture, if i am not wrong i can also connect a db9 connector to my PIC12 and using the correct cable to connect
please correct me if i am wrong,
now i am using 555timer to make my pwm with different values of r2 to get a 50% duty cycle for each of the different freq that i want to use, therefore i would need to switch the wires to the correct resistor for my desired freq,
moving forward i only wan to change the code in my program to...
eventually i wanna control the everything from my PC and not tuning the potential meter for the freq i want that is why i am thinking of using a controller type..
what i am looking is to build a uC so that i do not need to use a bulky signal generator. I also dun wish to spend so much buying a...
Ok, i understand.
So does this connection sound ok, or am i missing on some components
8051 -> MAX232 -> RS232 ->Laptop(Using RS232 to usb cable)
and using KEIL to flash my 8051
oh, ok pradon my inexperience in this.
so i can download the development tools from PIC and buy their microcontrollers and i connect it to my pc and start doing my code?
what if i decide to use a 8051 ic chip, what program can i download to write my code and how can i compile my code into my...
Hi people,
I am new in these area of microcontroller.
I needto use microcontroller to design a square wave of 50hz with a duty cycle of 50%
but first of all i have alot of qns hopefully you guys can help.
1) what program can i use to program my max232
2) if i can create the circuit on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
