Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear all,
Hope everybody is fine. I am interested to design a power amplifier for RFID applications (frequency ranging from 7MHz to 9MHz). For the said purpose i had designed PA by using MOSFET but now i am interested to replace MOSFET with CMOS Transistor. But unfortunately i am unable to...
Dear all,
Hope everybody is fine. I am interested to design a power amplifier for RFID applications (frequency ranging from 7MHz to 9MHz). For the said purpose i had designed PA by using MOSFET but now i am interested to replace MOSFET with CMOS Transistor. But unfortunately i am unable to...
Dear All,
Hope you all are doing well with good health. Here i would like t ask for one favor that i am going to design RF Transmitter at frequency of 8.2 MHz, which will be used for RFID application (i.e Electronic Article Surveillance system). For designing purpose i used Altium Designer 16.0...
Dear FvM,
Thanks for your reply, i would like to covert SPICE file for Altium Spice Model file for simulation in Altium Designer.... I shall be highly grateful to you for this act of kindness ...
Regards
Hello every one,
I hope you all are fine and enjoying your time, here i have to requested to ask one question only that i have LTSpice model file and i would like to use these file in Altium Designer, so please suggest me how can i use these files in the said software and also which tool can be...
Importing LTspice model to Altium Designer Simulation Model File
Hi All,
Hope everybody is fine and doing well with good health. i am little confused that i have LTspice Model files and unable to use (Configure) in Altium Designer 16.0 version. Actually i am new in this field and want to learn...
Dear Respected Sir/Madam/friends,
I hope everyone is doing well with good health. I have designed my own library in Altium Designer (16.0) which includes many Passive components and ICs. i would like to simulate circuit in Altium Designer, which needs SPICE Model File for each component. I...
Dear Respected Sir/Madam/friends,
I hope you all are doing well with good health. I have designed my own library in Altium Designer (16.0) which includes many Active/Passive components and ICs. i would like to simulate circuit in Altium Designer 16.0, which needs SPICE Model File for each...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
