Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
gps front end design
I want to design a gps front-end to collect IF sampling data.
but i find gps receiver chip has usually two bits output sampling data, I wish to be able to find a chip whose IF(immediate frequency) is analoy output, thus i can obtain the data i want through ADC.
can you give...
rf transceiver.....
it is up to your design,if you only want a simple structure,you can only add a PA that meet your disign requirement,such as IP3,gain and so on.
Added after 3 minutes:
add more:
there are different consideration in terminal to system equipment
Digital IF Receiver
you can design a lab board to implement some function and ensure them work well, and then design whe whole system based on above the laboratory.
that is to say, you can transform the signal into time frequency domain with Gabor transform. and then process the new signal, finally you can transform the processed signal into results signal with Gabor inverse transform.
i think Gabor filter is similar to FFT transform.
wish it helpful.
digital resonator filter
digital fiter design is very easy to use the matlab.
it supplies many function and module for implementing digital fiter design and analysis.
you can refer to related matlab books.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.