Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Please left the message if you want to design a new transformer...!
by given me the
i. topology
ii. input voltage range
iii. output voltage
iv. IC number or mosfet
Normall ....for input 12V. you need to boost up the voltage from 12V to 110vac or 220vac
Push-pull is the good selection..then using the half bridge to convert the voltage in AC ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
