Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Draw the board outline in MECHANICAL layer in Altium. Generate the mechanical gerber along with the other layers and send it to pcb fabricator.
This should solve your problem.
-Nishal
Open the ethernet connector from library file
Enable all layers by using menu "Tools" -> "Layers & Colors...". Click on "All Layers ON"
You should be able to view the hidden track by now. Click and delete the unwanted track
To place the mechanical pins, use menu "Place" -> "Pad" to insert a pad...
Hi all,
I am developing a Diesel Engine speed governor using PIC which senses the rpm from a Magnetic Pickup from flywheel teeth. The output of the PID is controlling a actuator
The output couldn't stabilise even P gain is adjusted.
I have few doubts to clarify.
1. How to determine the...
Hi all,
I am trying to interface PIC16f876a with Frequency meter having Modbus RTU protocol (9600, 8, E, 1). I could able to view the frequency data from PC using Modbus Poll software. But it fails to respond when I send it from pic with the same hex codes that is sent by the modbus software. I...
I am having the same PIR Motion detector module. I tried connecting a 10k variable resistor from "CDS" pin to ground. But nothing happens in timing when varied. My module takes 4 min to set the output to low once the motion is detected. Is there any other way to adjust the timing?
-Nishal
Re: s1d13742 display mirror
Firstly, the schematic is not readable due to low image quality.
As per your reply, we can set our focus to SSD1963 since the chip is warming. Display may be flickering due to chip temperature rise beyond its normal working temperature.
Try these steps...
Re: s1d13742 display mirror
Hi SSureshtronics,
It is hard to figure out without seeing the schematic / code.
As a debug procedure, try the following.
1. Write a separate code to display check patterns on the display. Try to include only display related functions and delete all other functions...
Hi
I need to find the underground 33kv power cable fault. Know it could find by using High voltage Thumper. But don't know much. Can anyone provide detailed information or Thumper schematics
Your help will be highly appreciable!!
Nishal
Hi all,
I am a Freelance PCB Designer from Cochin, Kerala, India. My expertise is on Altium. Also done projects on Protel (all versions), Orcad, Ares
Nishal
E-mail : nishaldisilva@gmail.com
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
