Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by nio_4

  1. N

    drive a stepper motor by SLA7062

    assembly code motor drive hey, I'm currently using the SLA7062M unipolar stepper motor driver/translator . I' would like to ask as about that, how can i control this chip with microcontroler-PIC. I use the PIC16F876 and i've clock frequency 10MHz for timing. So, the instruction word is tc=...
  2. N

    PIC control stepper motor with SLA7062 driver

    hey, I'm currently using the SLA7062M unipolar stepper motor driver/translator . I' would like to ask as about that, how can i control this chip with microcontroler-PIC. I use the PIC16F876 and i've clock frequency 10MHz for timing. So, the instruction word is tc= 0,4 μsec. More over, i saw...
  3. N

    MPLAB ICD2 Programmer for PIC

    hoe programmeer ik pic ...maby the problem is the cable which we use for the conection. The conection need 1:1 serial cable.
  4. N

    Problem with IC-Prog trying to program PIC16FXXX

    ic prog not working hi, i have winpic800 and is working fine!!! but it can't read the PIC16F876 when is programmed
  5. N

    MPLAB ICD2 Programmer for PIC

    mplab icd 2 programmer can you tell me how is the good voltage value for each pin on serial ports???
See more

Part and Inventory Search

Back
Top