Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi bigboss and Pancho,
Now I'm understand my mistake. Like what bigboss said, I need to simulate 1 parameter at time.
This is because I used PORT1 to simulate OIP3 which needs 2 supply. I need to have just 1 supply for p1dB simulation.
Is there any way we can simulate both parameters at the...
Hi Bigboss,
I won't have any problem when I run P1dB and OIP3 separately (means I activate only one simulator at time). But if I want to simulate both parameters at the same time, the error message pop-out.
I tried both of your opinions but the error is still there.
What else can I do? Does...
Hi,
I am doing simulation in ADS 2013 for OIP3 (3rd order Intermodulation) and P1dB (1dB compression).
Attach below is my OIP3 Setup.
P1dB Setup
The problem is when I'm simulate both controller, there are warning:
"For source Port1, (1xFreq[2] = 2.001e+09 Hz) is 1e+06 Hz away from the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
