Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
I have eeg signal with noise.then i have used tv filter to remove noise. but the changes in the output i would like to be visible.for that i would like to calculate snr. Do anyone have matlab code for that.
i have interface ad7796 chip to Atmega 16 using SPI. The input is taken from two strain gauges and connected to the ad7796 chip and the output is viewing through LCD. But i am getting zero value as output. i am attaching the code. I need help.
The code is given below.
#include <avr/io.h>...
can anyone help me giving spi embedded c code for interfacing between ad7796 and atmega 16. ad7796 is a Low Power, 16-/24-Bit Sigma-Delta ADC for Bridge Sensors. the foil type strain gauge output is connected to the atmega 16 through ad7796. the interfacing by spi protocol. help needed.
i am using ad7796 for connecting with strain gauge in my project. can we do so. ad7796 is Low Power, 16-Bit Sigma-Delta ADC for Bridge Sensors. i am trying to interface ad7796 with atmega 16.that is 8 bit microcontroller with spi interface. is it possible.can anyone help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
