Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey Andre,
Thanks for your reply. I am talking about the error markers on NetC1_1, you can see them on the trace as well as the component pads as you go along the path. Pads of J2, G1, C1 and L1 are affected with the trace. It is not a mechanical layer of the component.
Hello everyone,
I am laying out an RF board in Altium and I got 75 ohm and 50 ohm traces and proper rules setup for each. The particular trace as shown in the attached picture is a 75 ohm trace which has error markers that does not disappear even when I reset all markers. As you can see the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.