Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
For Undergraduate in Engineering, you must be really good in Calculus, including single variable and multivariable calculus. ODE are very important too. Not to forget some Complex Analysis aswell.
Re: Mosfet basic
Hope you find this useful:
If have not studied electronics before then I would definitely sugest Microelectronic Circuits by Sedra/Smith. Fourth edition would do. There one complete chapter on introduction to MOSFETs and then authors bulild on the basics in the next chapters...
Re: what is RMS voltage?
The RMS volatage term is used for alternating volatage. It means this: The roots mean square (rms) of an alternating voltage is the value of the direct p.d. which when applied across the same resistor, produces heat at the same rate as the mean rate of heat produced by...
Re: Microprocessor
Hope you find this useful:
The term 8-bit means that the ALU (Arithmetic Logic Unit), the internal registers, and most of the instructions are designed to work with 8-bit binary words.
It's not related to the data bus. For example: The 8086, which is a 16-bit microprocessor...
caspoc vs. protel or proteus
For Student Level in Electric Circuit simulation I would suggest PSpice (any version 8.0, 9.0, etc). There is very good manual available by Franco, who also has Electric Circuits textbook.
For more advanced work, I mean circuits having many parts I would recomment...
Which of these would be a better option for first time study in Numerical Analysis.
Can anyone tell whether Numerical Analysis would a prerequisite for studying: Wave Propagation and Antennas
Re: Usefull website for math
May I mention a sites with Math Tutorials:
hxxp://www.math.armstrong.edu/MathTutorial
hxxp://www.mathpower.com/tutorial.htm
hxxp://www.math.hmc.edu/calculus/tutorials
hxxp://math.about.com/od/discretemath
Hope these wille be useful
Re: fourier transform
If you are going to lean about fourier transforms for the first time, in that case I would like to suggest:
Advanced Enginering Mathematics by Erwin Kreyszig. The section to look at is Part C: Fourier Analysis and Partial Differential Equations. It dealswith the topic in...
Hi.
I don't think you need any advanced Maths for PCB design. If are using a Software like ExpressPCB with we are using at the moment then all you need is a general idea of co-ordinates. That's geometry.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
