Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Minimum trace thickness required in recent times
If only the ordinary two-tier board, a wide line of 8mil is ok, that is about 0.2mm,
If the alignment of the multi-layer board, the mill can process 5mil line, that is about 0.125mm
Best regards,
Niki
[email address removed]
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.